When you find that your roof has been broken or damaged by a wood shingle, the safest choice is to quickly repair it. This will help you prevent leaks while retaining the roof’s longevity for a while. Thankfully, the approach is a straightforward one which just takes a small amount of time and effort.Checkout Top Glaze Roofing Systems, Cranbourne for more info.
Materials/Tools
Hammer The Hammer
Pry bar, pry bar
Chisel Chisel
Ladder extension
Shingles for replacement
To Hacksaw
Block of Wood
Cement for Roofing
Nails For Roofing
Phase 1 – First protection comes
Roofing can be work that’s risky. Several safety measures should be taken into account in order to ensure a mission is performed without injury. Avoid walking, especially when it is raining, on a wooden roof. To do your roofing, pick a dry, warm day. To protect the ladder, always have someone close by as you climb up and down.
Stage 2 – Removal of the Shingle
Crack the broken bit and remove it into chunks using your hammer and chisel.
Phase 3 – Replacement Trim and Weigh
Cut out a new shingle so that it appears slightly smaller (approximately 3/8 narrower) than the gap it’s about to fill. Humidity and humidity cause shingles to expand over time, and the room can help prevent the replacement from cracking. You can have a couple of extras on hand if you happen to make a mistake, since most shingles are sold in packages.
Phase 4 – Make a room
Since shingles overlap, try raising it directly above the one that has been removed using a pry bar. You would be able to remove the old nails that have kept the damaged one in place in this way. These can be done best with a hacksaw. Be sure to remove any smaller fragments of the previous shingles as well.
Phase 5 – Substitute for
In the empty location, put the new one, enabling around 1⁄4 inch to hang down past the surrounding shingles. At a 45 degree angle, drive two nails into the centre.
Phase 6 – Position change
At the end of the new item, put a wood block where it sticks out. This will work between the shingle and the hammer as a buffer. Hit the block several times until it is aligned properly. Move the shingle back down into the right location above the replacement.
Hopefully, now you have a clear idea of who the wood shingle can fix. Know, if you end up running into a dilemma that is beyond your level of expertise, consult a specialist.
CONTACT INFO :
Top Glaze Roofing Systems
Factory 7/1441 S Gippsland Hwy, Cranbourne, VIC 3977
Phoene No. : 1800 88 77 98
Map URL to Embed